Same for the right leading edge

Started with drilling out two bent rivets. Used 1mm then 2mm and finally #40 to be sure to not mess up the holes. I then attached the ribs and stiffener into the right leading and finally I riveted the aftmost two rivets in every rib and attached the the inner rib completely.

starting with 1mm to get a good center start

all the way with 2mm

just enough with the #40 to be able to break the head off with a punch

the bar is next to the hole as not to deform the skin and rib while punching out the last part of the bad rivet

more yoga ;)