Panel version 3, mandatory extra annual in preparation for permanent permit to fly, started

Ordered some expensive but nice looking printed aluminium pieces for marking the switches and breakers.

Some screws are missing as they needed to be replaced, the Seat heat switch is not connected and installed and the same is thru for the TOGA button. Apart from that I can present the third version of the panel below:

Do not worry, the mag switches were just temporary hot while torquing the nuts.

The engine compartment part of the annual is done, some anti-chaffing improvements, all looks good. Still not enough rubbing from the baffling to clearly see where one should add some epoxy protection on the cowls. Probably at next annual.