Just realized that I did not post this here on the blog: I connected the wires for the flap motor to the GAD 27 and the flap switch. I was then able to make this little video:
Very significant as it is the first wiring that goes to the back of the plane.
Later I will hook up the flap position sensor. I can then program up to 8 steps. If i push the lever up or down it will move one step and if I hold it in the up position for more than 1 second it will go to 0 degrees (I will have -3 0 10 and full, maybe something between 10 and full but probably not.
Thats awesome! Is it a one setting or does it have more than one step. The flaps I mean.
ReplyDeleteGuess one, otherwise it would have been a lever, not a switch...
ReplyDeleteLater I will hook up the flap position sensor. I can then program up to 8 steps. If i push the lever up or down it will move one step and if I hold it in the up position for more than 1 second it will go to 0 degrees (I will have -3 0 10 and full, maybe something between 10 and full but probably not.
ReplyDeleteCool!
ReplyDelete