Match and finaldrilling

Did some match- and final-drilling on the innermost parts of the bottom skins (Did the right wing as well even if it is not mentioned at this time in the plans). And also final drilled the #19 holes for the access panel screws.

Then I fitted the Cleaveland C-frame parts to my C-frame, check the comments on the pictures, a typical example of what happens when you take however great measures... but only once ;)

match drilling, holes for the nutplates are in the skin but not in the rib when delivered

Final drilled to #19

Final drilled to #19

Old

Opening up the middle hole for the bigger die

smoothing up with the dremel

Mistake captured on "film", the dieholder is not in its correct position as I have not made the hole in the underlying wood

Missing roughly 13mm

An extra piece of wood under each feet and all is good again.